ECODRY 65 He plus 161065V31 1Ph 100-120 V 50/60 Hz

Leybold ECODRY 65 He plus – for helium recovery and closed circuits

The ECODRY 65 He plus is based on the ECODRY 65 plus and is optimised for permanent gases such as nitrogen, helium-3, helium-4, argon and neon – in certain set-ups also for SF₆. It achieves 55 m³/h for air and 52 m³/h for helium with an ultimate pressure below 0.03 mbar. Dimensions (623 × 320 × 298 mm), weight (around 43 kg) and flanges (DN 40 ISO-KF / DN 16 ISO-KF) are the same as on the ECODRY 65 plus.

Tested leak-tightness

Leybold specifies a leak rate below 5 × 10⁻⁸ mbar·l/s, confirmed by an integral leak test; each pump is supplied with a certificate confirming that it passed the test. This version deliberately does without a gas ballast – it would be a potential leak point and a source of unwanted gas contamination.

Typical applications

Helium recovery and recirculation in closed systems, cryostats, dilution refrigerators, leak detection and superconducting magnets.

Variants of the ECODRY 65 He plus

The ECODRY 65 He plus is available from Ehrler & Beck in two variants (part numbers 161065V32, 161065V31). The rated power is 1.2 kW for all variants (0.6 kW at ultimate pressure); the mains voltage ranges from 100–120 V to 200–240 V (50/60 Hz, 1-phase). The weight is around 43 kg.

Features of the ECODRY plus series

• Oil-free and clean: no oil, no particles, no dust in the pumping chamber; no odours
• Quiet: 52 dB(A) – below the level of a conversation
• Low maintenance: according to Leybold, up to five years without oil change or seal replacement
• Energy-efficient: 600 W power consumption at ultimate pressure, little waste heat
• Compact and mobile: small footprint, 1-phase mains connection
• Networkable: X104 interface (RS485) for monitoring and remote control

Pumping speed 50Hz	55
Pumping speed 60Hz	55
Ultimate pressure	0.03
Rated motor power 50Hz	1.2
Rated motor power 60Hz	1.2
Weight	43
Length	62.3
Width	32
Height	29.8
Inlet connection flange	DN 40 ISO-KF (NW40)
Outlet connection flange	DN 16 ISO-KF (NW16)
Noise level	52 dB(A)
Cooling method	Air cooling
Oil type	Oil-free

Convert units: vacuum and pressure units · Nm³/h to m³/h

Additional technical data